AC401: Activating and adjusting temperature

The Temperature ranges on the AC401 & AC403 are:

• Low Temperature Setting Between 5° to 19°
• High Temperature Setting Between 22° to 40°

Your Angelcare Monitor can be used to monitor the temperature in your baby’s room and sound an alarm if the temperature is either too high or too low.

A triple beep will sound if the temperature is outside the programmed range. In addition to this the icon will flash on the screen. 

The temperature sensor in the Nursery Unit is very sensitive and readings can be affected by (e.g.) cold or warm draughts, fans, placement next to a cold window or above a heating radiator.

Your Nursery Unit should not be placed on the floor, it should be at approx crib height. Temperatures can vary from floor to ceiling and you need to ensure that your Nursery Unit is reading the correct level that you baby is placed at. 

To activate the Temperature Setting ON & OFF & Adjusting the Temperature

1. Press the MENU button briefly 5 times until you see "OF, a Snowflake & Sun Icon displayed on the screen
2. Press the UP arrow on the Parent Unit until you see "ON" and press SELECT (you must do this at this point) to confirm activation
3. Press the MENU button and the Snowflake Icon will flash
4. Press the UP or DOWN arrow on the Parent Unit to select the lowest temperature you would like in the Nursery
5. Press SELECT (you must do this at this point) to confirm activation
6. Press the MENU button and the Sun Icon will flash
7. Press the UP or DOWN arrow on the Parent Unit to select the highest temperature you would like in the Nursery
8. Press SELECT (you must do this at this point) to confirm activation