Firstly, has the sensitivity of the monitor been changed accidentally. If the setting is too high the Sensor Pad can continue to detect movement near to the crib such as floorboards, central heating, even something as light as a fan.
In addition to this when monitoring baby’s movements you should not use a mobile, toy that plays music etc. in the crib – these all emit a form of movement, albeit small on the surface of the mattress or the crib itself. Whilst the Sensor Pad is able to detect movement it is unable to distinguish between baby’s movement or something inside or attached to the crib.
Also, please do not place the crib directly against a wall, skirting board as it can detect movements from piping etc.
Lastly, if you are using a bedside crib you are unable to use the Sensor Pad when it is attached/touching your bed. When any bedside crib is attached/next to your bed the Sensor Pad cannot be used as it is sensitive enough to detect your movements in your bed.
The Sensor Pad cannot differentiate between the movements of baby or you and may not alarm
If you have not already done so carry out the Four Corner Test below. This will establish the correct level of sensitivity required for your baby`s mattress so you can adjust accordingly (only if required):
4 corner test
NOTE: Your baby must NOT be in the crib during this test:
- Check that the sensitivity in the Parent Unit MENU by pressing the MENU icon, bottom right on screen:
Press the SUB MENU (SETTINGS) icon, top right of the screen
When you press the Sensor Pad sensitivity icon the sensitivity level is indicated on top of screen (L1 to L5 – 5 being the highest level) – this needs to be at L3, this is the factory setting. You can change this by pressing the + or - button on the right side of the Parent Unit
When you have L3 flashing on the screen press the back arrow on top right of the screen to come out of the SUB MENU
- Check that the Sensor Pad is in the middle of the crib underneath the mattress:
Ensure that the Sensor Pad cord is fed through the base of the crib using the cord cover kit to secure the cord
All cords must be kept out of reach of your baby at all times
The Nursery Unit must be at least 3ft away from the crib
- Plug the Sensor Pad jack into the Nursery Unit
- Switch the Nursery Unit & Parent Unit ON
- Gently place your hand in the furthest corner of the mattress & and wait for 20 seconds
- *If the green light flashes on the Nursery Unit registering your hand then the sensitivity is correct and repeat in the remaining 3 corners
- Remove your hand from the mattress and step away from the crib. The Sensor Pad is sensitive enough to detect your movement if you are touching the crib
- **Due to the lack of movement, after 15 seconds a single beep (The Rouse Alarm) will be emitted from the Nursery Unit
- After a further 5 seconds a series of continuous beeps (The Main Alarm) will sound from the Nursery Unit & Parent Unit
- Place your hand on the mattress and after a few seconds the alarm will cease as the Sensor Pad will have detected your movement
- *If the green light does not flash when you touch any of the corners please adjust the sensitivity by turning it up another level and repeat the Four Corner Test again
- **If however the monitor does not alarm when you step away from the crib reduce the sensitivity down 1 level and repeat the Four Corner Test, keep adjusting this until the alarm sounds ensuring that the movements is still detected in all four corners
Try this new setting over the next couple of nights and monitor the amount of false alarms you have, re-adjust if necessary by turning the Sensitivity up another level
Comments
0 comments
Please sign in to leave a comment.