AC417: Adding replacement sensor pad

• Power OFF the Parent & Camera Unit

• Remove the battery from the original Sensor Pad and put aside to prevent any mix up

• Place new battery received into replacement Sensor Pad

• Power off the Parent & Camera Unit – remove batteries from both units for approx. 20 seconds and then replace

• Power ON the Camera & Parent Unit and press the settings icon on the Parent Unit screen

• Please Note: you have approx. 15 seconds to carry out the following steps before the alarm sounds. If this happens you will need to start again

• Press the pairing icon (bottom left icon) to enter pairing menu

If there is a red bin in the top row press this and a red TICK icon will show:

• Press the red TICK icon to delete the red bin

• Press and hold the blue cross until it turns to a blue circle

• The green power light on the Parent Unit will flash slowly to indicate connecting

• Once connected the red bin will appear again to indicate the Sensor Pad is connected

If there is no red bin icon in the top row press and hold the blue cross until it turns to a blue circle:

• The green power light on the Parent Unit will flash slowly to indicate connecting

Once connected the red bin will appear again to indicate the Sensor Pad is connected